Beside the free run mode, which is not trigger based, the ANPR LUMO has 3 options for external triggers:
- Digital input
- TCP
- HTTP
All of these triggers can work in different modes which can be selected in the configuration tabs. The different modes are:
Start – Stop
Starts reading on digital input change or TCP/HTTP trigger and stops reading on digital input change/ TCP/HTTP request.
Start-Time
Starts reading on digital input change/ TCP/HTTP trigger and stops when the specified time has passed
Start-Sequence
Starts reading on digital input change/ TCP/HTTP trigger and stops when the specified sequence frames has passed
Single shot
Starts reading on digital input change/ TCP/HTTP trigger and ends after grabbing one shot
Single line
This mode only counts when digital input is used. The LUMO start reading when the digital input changes from low to high and stops when this input is low again.
For more detailed information see the install guide on portal.nedapidentification.com