At the button below you can download the latest UHFTOOL, this tool can be used to configure the uPASS readers.

Download UHFTool

this tool can be used for the following products:

• uPASS Access
• uPASS Reach
• uPASS Target
• uPASS Go

With this tool you can also upgrade the readers to the latest firmware, the firmware is available within this tool.

Release notes

Version 4.12

• add accelerometer (roll/pitch)
• add tamper xyz setpoint

Included firmware updates:

uPASS Go firmware version 1.18:

• handle tamper xyz setpoint
• add command 0321 get tamper status
• add command 0322 set tamper xyz setpoint
• bug fixed: OSDP buzzer control
• read tid + custom read
• add command 0450 Linux powerdown
• disable command 039A SimulateID (unless unlocked)
• add verify kill password function
• update OSDP device address (without restart)

Previous releases

Version 4.11

• hide vehicle-hold-time if not in dual-id mode.
• Vietnam region 3 for uPASS Go

Included firmware updates:

uPASS Go firmware version 1.17:

• OSDP vendor id corrected
• OSDP FMT_RAW for wiegand tags

uPASS Target firmware version 3.11:

• OSDP vendor id corrected

Version 4.10

This version has some improvements in the User interface

• improved communication
• added output message format option to send wiegand data format over OSDP (uPASS Go only)

Included firmware updates:

uPASS Go version 1.16:

• Led status (pink color) when no OSDP communication is established. 
• Support for wiegand format over OSDP
• Bugfix: NedapXS formatted tags were not read when the option "enable only valid custcode" was enabled.

Version 4.8

This version has some improvements in the User interface

• added access/kill password check
• Led dimming auto enabled

Included firmware updates:

uPASS Go version 1.14:

• Change in default output power (28.0 dBm)
• removed unused data bytes in certain commands
• bugfix: Check valid customercodes

Version 4.7

This version has an improved firmware download for the uPASS Go reader.

General

Added functionality to convert the EPC number from decimal to binary, this can be enabled using the Extra Output settings.

Note 1: the conversion works up to a maximum EPC number length of 128 bits (=16 bytes = 32 digits).

Note 2: the conversion changes the length! In the example below source EPC number is 32 bits (=8 digits) 🡪 converts into Wiegand 27-bit.

Included firmware updates:

uPASS Go version 1.13:

• Lower power consumption
• Led automatic dimming mode added
• Improvements on relay timing (configured relay hold-time was not correctly)
• Improvements on Led and buzzer timing
• Internal communication improvements

Version 4.5

This version has some small improvements and bugfixes.

General

Wiegand: The option "overrule wiegand formatted tags" is now available for the uPASS Go.

Bugfix

uPASS Go Firmware: an important update is available that could lead during special configurations to an unrecoverable device (uPASS Go firmware version 1.12)